Lossy and Lossless Inductance Simulators and Universal Filters Employing a New Versatile Active Block

MOHAMMAD FASEEHUDDIN, Jahariah Sampe, Sadia Shireen, Sawal Hamid Md Ali

Abstract


In this paper six new implementations for realizing lossy and lossless active inductors are presented. The new topologies are obtained using a newly formulated active block namely, the extra X current conveyor transconductance amplifier (EXCCTA). The designed grounded inductor simulators (GIS) require only three grounded passive elements for implementation which is desirable for integrated circuit fabrication. Moreover, the inductance simulators are electronically tunable and free from matching requirements. Additionally, two structures of universal filters are also proposed. The voltage mode (VM) filter is multi input single output (MISO) structure and uses canonical number of passive components. The current mode (CM) filter is a single input multi output (SIMO) structure with grounded passive elements. The filter structures can realize all five standard filter responses without any matching conditions and have features of low/ high output impedance, low active and passive sensitivities, tunability, independent control of pole frequency and quality factor. The effect of non-idealities on the inductor and filter topologies are also analyzed. The simulations are performed in 0.18μm parameters from TSMC in Spice to validate the theoretical predictions. Experimental results using AD844 and LM13700 integrated circuits (ICs) for the proposed inductor and filter are also provided to further ascertain the feasibility of the proposed solutions.

Keywords


Active inductor; Current mode; Current conveyor; Filter; Tunability

Full Text:

PDF

References


İbrahim, M. A., Minaei, S., Yüce, E., Herencsar, N., & Koton, J. (2012). Lossy/lossless floating/grounded inductance simulation using one DDCC.

Yuce, E. (2006). Floating inductance, FDNR and capacitance simulation circuit employing only grounded passive elements. International Journal of Electronics, 93(10), 679-688.

Metin, B., & Cicekoglu, O. (2006). A novel floating lossy inductance realization topology with NICs using current conveyors. IEEE Transactions On Circuits And Systems II: Express Briefs, 53(6), 483-486.

Cicekoglu, M. O. (1998). Active simulation of grounded inductors with CCII+ s and grounded passive elements. International Journal of Electronics, 85(4), 455-462.

Alpaslan, H., & Yuce, E. (2015). Inverting CFOA based lossless and lossy grounded inductor simulators. Circuits, Systems, and Signal Processing, 34(10), 3081-3100.

Ferri, G., & Guerrini, N. C. (2003). Low-voltage low-power CMOS current conveyors. Springer Science & Business Media.

Mohan, P. A. (2012). Current-mode VLSI analog filters: design and applications. Springer Science & Business Media.

Alzaher, H. A. (2008). A CMOS digitally programmable universal current-mode filter. IEEE Transactions on Circuits and Systems II: Express Briefs, 55(8), 758-762.

Van Valkenburg, M. E. (1982). Analog filter design (pp. 136-137). Holt, Rinehart, and Winston.

Pathak, J. K., Singh, A. K., & Senani, R. (2016). New canonic lossy inductor using a single CDBA and its application. International Journal of Electronics, 103(1), 1-13.

Metin, B. (2012). Canonical inductor simulators with grounded capacitors using DCCII. International Journal of Electronics, 99(7), 1027-1035.

Pandey, R., Pandey, N., Paul, S. K., Singh, A., Sriram, B., & Trivedi, K. (2011). New topologies of lossless grounded inductor using OTRA. Journal of Electrical and Computer Engineering, 2011, 7.

Yuce, E., & Minaei, S. (2017). Commercially Available Active Device Based Grounded Inductor Simulator and Universal Filter with Improved Low Frequency Performances. Journal of Circuits, Systems and Computers, 26(04), 1750052.

Metin, B., Herencsar, N., Koton, J., & Horng, J. W. (2014). DCCII-based novel lossless grounded inductance simulators with no element matching constrains. Radioeng J, 23, 532-4538.

Çam, U., Kaçar, F., Cicekoglu, O., Kuntman, H., & Kuntman, A. (2003). Novel grounded parallel immittance simulator topologies employing single OTRA. AEU-International Journal of Electronics and Communications, 57(4), 287-290.

Yuce, E., Minaei, S., & Cicekoglu, O. (2005). A novel grounded inductor realization using a minimum number of active and passive components. Etri Journal, 27(4), 427-432.

Yuce, E., Minaei, S., & Cicekoglu, O. (2006). Limitations of the simulated inductors based on a single current conveyor. IEEE Transactions on Circuits and Systems I: Regular Papers, 53(12), 2860-2867.

Yuce, E., & Minaei, S. (2008). A modified CFOA and its applications to simulated inductors, capacitance multipliers, and analog filters. IEEE Transactions on Circuits and Systems I: Regular Papers, 55(1), 266-275.

Yuce, E. (2009). Novel lossless and lossy grounded inductor simulators consisting of a canonical number of components. Analog Integrated Circuits and Signal Processing, 59(1), 77-82.

Yuce, E., & Minaei, S. (2009). On the realization of simulated inductors with reduced parasitic impedance effects. Circuits, Systems, and Signal Processing, 28(3), 451-465.

Kumar, P., & Senani, R. (2010). New grounded simulated inductance circuit using a single PFTFN. Analog Integrated Circuits and Signal Processing, 62(1), 105.

Kaçar, F., & Yeşil, A. (2010). Novel grounded parallel inductance simulators realization using a minimum number of active and passive components. Microelectronics Journal, 41(10), 632-638.

Gupta, A., Senani, R., Bhaskar, D. R., & Singh, A. K. (2012). OTRA-based grounded-FDNR and grounded-inductance simulators and their applications. Circuits, Systems, and Signal Processing, 31(2), 489-499.

Kacar, F., & Kuntman, H. (2011). CFOA-based lossless and lossy inductance simulators. Radioengineering, 20(3), 627-631.

Kaçar, F., Yeşil, A., Minaei, S., & Kuntman, H. (2014). Positive/negative lossy/lossless grounded inductance simulators employing single VDCC and only two passive elements. AEU-International Journal of Electronics and Communications, 68(1), 73-78.

Maheshwari, S. (2013). Current conveyor all-pass sections: brief review and novel solution. The Scientific World Journal, 2013.

Senani, R. (1996). A simple approach of deriving single-input-multiple-output current-mode biquad filters. Frequenz, 50(5-6), 124-127.

Horng, J. W. (2001). High-input impedance voltage-mode universal biquadratic filter using three plus-type CCIIs. IEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, 48(10), 996-997.

Horng, J. W., Hsu, C. H., & Tseng, C. Y. (2012). High input impedance voltage-mode universal biquadratic filters with three inputs using three CCs and grounding capacitors. Radioengineering, 21(1), 290-296.

Herencsar, N., Koton, J., & Vrba, K. (2009). Single CCTA-Based Universal BiquadraticFilters Employing Minimum Components.

International Journal of Computer and Electrical Engineering, 1(3), 307.

Horng, J. W., & Jhao, Z. Y. (2013). Voltage-mode universal biquadratic filter using single DVCC. ISRN Electronics, 2013.

Ranjan, A., & Paul, S. K. (2011). Voltage mode universal biquad using CCCII. Active and Passive Electronic Components, 2011.

Pushkar, K. L., Bhaskar, D. R., & Prasad, D. (2013). A new MISO-type voltage-mode universal biquad using single VD-DIBA. ISRN Electronics, 2013.

Pathak, J. K., Singh, A. K., & Senani, R. (2013). New voltage mode universal filters using only two CDBAs. ISRN Electronics, 2013.

Chang, C. M., & Chen, H. P. (2003). Universal capacitor-grounded voltage-mode filter with three inputs and a single output. International Journal of Electronics, 90(6), 401-406.

Chang, C. M., & Chen, H. P. (2005). Single FDCCII-based tunable universal voltage-mode filter. Circuits, Systems, and Signal Processing, 24(2), 221-227.

Chiu, W. Y., & Horng, J. W. (2007). High-input and low-output impedance voltage-mode universal biquadratic filter using DDCCs. IEEE Transactions on Circuits and Systems II: Express Briefs, 54(8), 649-652.

Sagbas, M., Ayten, U. E., & Sedef, H. (2010). Current and voltage transfer function filters using a single active device. IET circuits, devices & systems, 4(1), 78-86.

Prasad, D., Bhaskar, D. R., & Singh, A. K. (2009). Universal current-mode biquad filter using dual output current differencing transconductance amplifier. AEU-International Journal of Electronics and Communications, 63(6), 497-501.

Beg, P., & Maheshwari, S. (2014). Generalized filter topology using grounded components and single novel active element. Circuits, Systems, and Signal Processing, 33(11), 3603-3619.

Jerabek, J., & Vrba, K. (2010). SIMO type low-input and high-output impedance current-mode universal filter employing three universal current conveyors. AEU-International Journal of Electronics and Communications, 64(6), 588-593.

Wang, C., Liu, H., & Zhao, Y. (2008). A new current-mode current-controlled universal filter based on CCCII (±). Circuits, Systems, and Signal Processing, 27(5), 673-682.


Refbacks

  • There are currently no refbacks.


Copyright (c) 2018 Informacije MIDEM